Red Oak Quarter Flake Tiger wood veneer 48" x 24" on paper backer AA grade

Description

Red Oak Quartered
Flake Figured Tiger
wood veneer 48" x 24" x 1/40" thickness with paper backer.
*GRAIN RUNS SHORTER DIRECTION*.
This is AA rated (scale A-AA) because of the amount of flake or pattern in each sheet, which is expected to cover 50-75% in this grade. Usually not as good on flake as White Oak. Photos are representative and actual product will vary in color and grain, but is expected to be of this quality. Some pictures may be of other sizes, customer projects, and wet or finished veneer.
Ships rolled in long narrow box with a
pplication instructions included. Each sheet carefully inspected and selected. Other sizes and backers available. Red Oak color range is a straw light color to a slight pink color. Paper backer is Beige and blends well.
Trust the experience, knowledge, and reputation that has served the wood industry since 1995.
Other sizes and unbacked veneer may be available.
About pictures
:
Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.
Backed products
come with complete application instructions
that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.
Thickness
:
(will not always be exactly correct, but relatively close)
Paper-backed veneers = 1/40”
Wood-backed veneers = 1/25”
Raw plain veneer with no backing = 1/32”-1/42”
How to cut
:
generally cut with a razor/box knife or similar tools and some type of straight edge.
How to apply
:
Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying.
How to finish
:
most any conventional finishing products can be used with veneer that is applied correctly.
Disclaimer:
Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldn’t impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect.
Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.