Maple wood veneer 24"x 96" with peel and stick PSA adhesive 1/40" thickness A

Description

Maple wood veneer sheet 24" x 96" with peel and stick pressure sensitive adhesive backer 2' x 8' x 1/40" thickness with PSA backer A grade quality. Pictures are representative of the product and will vary in grain and color since this is a natural product. Ships rolled in long narrow box with application instructions. Each sheet carefully inspected and packaged by our company. Only 3M quality adhesive used for this product. Some photos may show other sizes, other helpful products (sold separately), customer projects and wet or finished veneer. This product is unfinished. Other sizes and backers available. Maple will darken and yellow slightly when finished. Can be stained any color and is the best wood for that purpose. Faster shipping usually available.
No need for messy, smelly expensive contact cement. Peel off the backing and apply to clean smooth surface and trim with utility knife or similar. Simple to use and each order comes with complete and detailed instructions. Finish as desired with most any finish.
Trust the knowledge, experience and reputation of our company. Serving the wood industry since 1995.
About pictures
: Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.
Backed products come with complete application instructions that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.
Thickness
: (will not always be exactly correct, but relatively close)
Paper-backed veneers = 1/40”
Wood-backed veneers = 1/25”
Raw plain veneer with no backing = 1/32”-1/42”
How to cut: Generally cut with a razor/box knife or similar tools and some type of straight edge.
How to apply
: Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying. This product has adhesive already on it, so this doesn't apply here.
How to finish
: Most any conventional finishing products can be used with veneer that is applied correctly. Staining or clear coating is fine.
Disclaimer:
Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldn’t impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect.
Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection
.