-40%
Ebony Brown composite wood veneer sheet 12" x 13" raw no backing 1/42" thick 607
$ 9.24
- Description
- Size Guide
Description
Brown Ebony composite wood veneer sheet 12" x 13" raw with no backing1/42" thickness.
Composite veneer is real wood that has been dyed and cut for consistent, clean, defect free design appearance. Otherwise, just like normal wood veneer. Grain runs across the 12" and with the 13" length as seen in second photo. Some photos may be other sizes and wet or finished so the color change from dry to wet grain can be shown. Code # 607. Each piece carefully inspected and packaged with care by our company. High quality and pretty product when finished.
Trust the experience, knowledge, and reputation that has served the wood industry and novices since 1995.
About pictures
:
Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.
Backed products
come with complete application instructions
that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.
Thickness
:
(will not always be exactly correct, but relatively close)
Paper-backed veneers = 1/40”
Wood-backed veneers = 1/25”
Raw plain veneer with no backing = 1/32”-1/42”
How to cut
:
generally cut with a razor/box knife or similar tools and some type of straight edge.
How to apply
:
Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying.
How to finish
:
most any conventional finishing products can be used with veneer that is applied correctly.
Disclaimer:
Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldn’t impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect.
Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.