Cerejeira Crotch wood veneer 12" x 32" raw no backing 1/32" thickness "A" grade

Description

Cerejeira Crotch wood veneer 12" x 32"
raw no backing. Measured from midpoints. ONE piece per price. 1/32" thickness. "A" grade quality. All pieces in sequence and matching pulled from bundle # 13. Photos taken wet with water to show color and grain more vividly. Some cracking usually exists with crotch woods and they will require flattening.
Trust the experience, knowledge, and reputation that has served the wood industry and novices since 1995.
Visit My eBay Store: JSO Wood Products
Other sizes and backed veneer may be available.
Some notes about raw veneers in burl/crotches form:
1) Raw veneer typically has some type of cracking, end splitting, small holes or voids as it is a fragile product. Most cracking or end splitting will minimize when laminated to whatever surface you are using but may need some wood filler. Holes or voids are usually filled with wood filler also or a patch (from other area of same piece) can be put in the hole or void.
2) Pricing is
per piece
, not for the entire bundle. If you need more than one piece, we would give some type of discount based on the quantity.
3) Burls/crotches from the same bundle are often used to lay out side by side and end over end to make larger pieces. They will match up reasonably well after being trimmed to square or rectangular forms and this is what is done to make bigger pieces from the piece you are viewing.
4) You may see band ties or strings or labels or chalk writing, which all would be removed prior to shipping.
Visit My eBay Store: JSO Wood Products
Other sizes and backed veneer may be available.
About pictures
:
Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.
Backed products
come with complete application instructions
that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.
Thickness
:
(will not always be exactly correct, but relatively close)
Paper-backed veneers = 1/40”
Wood-backed veneers = 1/25”
Raw plain veneer with no backing = 1/32”-1/42”
How to cut
:
generally cut with a razor/box knife or similar tools and some type of straight edge is typically used.
How to apply
:
Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying.
How to finish
:
most any conventional finishing products can be used with veneer that is applied correctly.
Disclaimer:
Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldn’t impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect.
Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.