Carpathian Elm Burl wood veneer 9" x 20" no backing raw 1/42" thick AAA grade

Description

Carpathian Elm Burl wood veneer 9" x 20" with no backing raw veneer AAA top quality grade 1/42" thickness. One piece per price as pictured. All pieces in sequence and matching if multiple pieces are needed. Burls often have small holes that may need wood filler and minor cracks that will mend. Some flattening is generally needed prior to lamination/sanding/finish and is very easy to accomplish. If any knife marks are shown in photos, they will sand off. Pulled from bundle # 223.
Trust the experience, knowledge, and reputation that has served thew wood industry and novices since 1995.
Visit My eBay Store: JSO Wood Products
Other sizes and backed veneer may be available.
About pictures
:
Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.
Backed products
come with complete application instructions
that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.
Thickness
:
(will not always be exactly correct, but relatively close)
Paper-backed veneers = 1/40”
Wood-backed veneers = 1/25”
Raw plain veneer with no backing = 1/32”-1/42”
How to cut
:
generally cut with a razor/box knife or similar tools and some type of straight edge is typically used.
How to apply
:
Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying.
How to finish
:
most any conventional finishing products can be used with veneer that is applied correctly.
Disclaimer:
Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and
shouldn't
impact overall quality or satisfaction. There may also be some minor wood filler used or needed to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect since it is basically a sliced up tree.
Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.