[3DMakerWorld] Kitronik Servo:Lite board for :MOVE mini

Description

Key Features:
Connect two servos in standard configuration and can drive up to 3 servos if the addressable 'ZIP' LEDs aren’t needed.
Powered by 3 AAA batteries that also supply power to the BBC microbit (not supplied).
On / off switch.
5 x RGB addressable ZIP LEDs (NeoPixel compatible). Additional external ZIP LEDs can be connected to the board.
The Servo:Lite board for the BBC micro:bit is a simple board that allows you to easily connect and control low power servo motors (servo's must be capable of operating at 3.3V) using the BBC micro:bit. It is connected to the micro:bit using five bolts. Connect two servos in standard configuration and it can drive up to 3 servos if the addressable 'ZIP' LEDs aren’t needed.
It is powered by 3 AAA batteries and also supplies power to the BBC micro:bit, the board features an On / off switch so when it's not in use the batteries won't drain.
The board also features 5 x RGB individually addressable ZIP LEDs (NeoPixel compatible) and additional external ZIP LEDs can be connected to the board as required.
Item Specifics
1 - Servo:Lite board with battery holder pre-fitted
5 - M3x8 Counter sunk Pozi Steel screws
1 - Perspex spacer
Size: 55 x 52 x 17mm
Required (not included): 3 x AAA Batteries, 1 x BBC microbit, servos, screwdriver
Note: Once the Servo:Lite board is attached to the microbit there is a maximum clearance of 6mm for the plastic sheath of the USB cable.